Monthly Archive: August 2015

When i load Isuzu IDSS software of NEXIQ 125032 USB link

When i load Isuzu IDSS software, it failed. And the software gives me this error prompt: “CRC error: the file C:Program FilesIDSS images2007icvch processedfullsizefullb606.rra doesnt match the file in the setup’s.cab file.” About this prompt of Nexiq USB Link 125032,…
Read more

What‘s the NEXIQ USB link code meaning?

When i install the Nexiq USB Link software ready, i start the engine, software prompt me error code 275.00, what’s the meaning?The NEXIQ 125032 USB driver is not installed correctly, so the software does not recognize the hardware. Please install the…
Read more

NEXIQ has been set up after well connected with vehicle

Nexiq 125032 USB Link has been set up after well connected with vehicle. The Bluetooth software provides a virtual serial COM port (Bluetooth Serial Port Profile). The COM port provides well communication between diagnostic base system and the NEXIQ USB…
Read more

Nexiq USB Link is nexiq data link adapter adds Bluetooth function

In early 2015, Nexiq Technologies discontinued the “tried and true” original Nexiq USB Link. This adapter had been around for around 7 years, and was wildly popular. One of the main reasons that the Nexuq USB Link became so popular…
Read more

How to install the X431 5C diagnostic connector?

How to install the X431 5C diagnostic connector 1) Locate vehicle’s DLC connector. The 16 pin diagnostic connector is generally located on the driver’s side, about 12inches away from the center of the dash board. 2) Plug the 5C diagnostic…
Read more