This is obdii365 tech support for Yanhua Mini ACDP with the following error message when connected to the mobile:
Configure ACDP device WIFI failed. Please retry
Yanhua ACDP tech support from obdii365.com:
You don’t select the right serial port for your ACDP bluetooth adapter.
Please select a USB serial port
Good to know: ACDP Bluetooth setup instruction
Step 1. Bluetooth adapter connection
Step 2. ACDP initial use setup
Step 3: Device ID binding
in detail…
Step 1. Bluetooth adapter connection
Plug the Bluetooth adapter into the PC USB port ( Make sure the driver is installed) and the PC is connected to WIFI
This is the Bluetooth adapter
Step 2. ACDP initial use setup
Run ACDP software on the PC desktop
Go to Mini ACDP setting – initial use settings
Initial use settings (ACDP)
the pc is connected to the wifi and confirm it has access to the internet
acdp hardware access power adapter
press and hold the “SET” button on the acdp device for about 7 seconds until the device buzzer’s
sounds, then release the “SET” button and click on “Next”
Initial use of settings (WIFI configuration)
If the PC is a laptop with WIFI access function, read [note 1]
If the PC is connected through a WIFI router with wired network, read [note 2]：If the PC with WIFI access function, Connect the PC to WIFI.
If the PC without WIFI access function, Connect the WIFI adapter with the PC USB, Connect the WIFI
and follow the steps below
select serial port
open
scan
device
wifi name
wifi password
start configuration
Yanhua ACDP Bluetooth connection success!
[note 2] If the PC without WIFI access function, the PC is connected through a WIFI router with wired network. Follow the steps shown as below.
ACDP WIFI connection success!
Step 3: Device ID binding
Go to id binding after wifi connection is done
Select device ID to bind
Confirm the device id and back
Confirm the device is bound and connected successfully
Job’s done!
Leave a Reply