It’s very simple to use Lonsdor K518ISE.
You see there is a range of other things but we’re just doing this key today.
So just show you the original key is this one and when you put that in the ignition, turn the ignition on and this light here that’s currently, flashing will go solid and then go out that shows that the system’s working.
So, go to “Immobilizer“.
There is a nice search function at the right corner of the machine.
Type F and choose “Ford”, then “China”.
We will see that years the classic focus’s, tap “Type 2”, then “Immobilizer”.
Read message ” Connect device (Car Key Programmer Lonsdor K518) OBD test cable with the vehicle OBD port, switch ignition one.”, tap “OK”.
Please insert the new key to be programmed. Note: It needs two right keys to start vehicle.
Identified number of programmed keys in car:2, select “OK”.
Programming, please wait…
Programming complete, successfully programmed key count (2).
So I’m going to test out because that should have jumped up to free rarely.
Just ignition on, insert back to see if the light goes solid and goes out.
And going to check another one, insert into the ignition and to see if the light goes solid and goes out, then the key is programmed successfully.
So they both work. So when it says keys programmed to it must have meant the new key count will be too, so there must have just been just this one key programmed at the time and the other key is gonna be this one the new one. To me that should say free, but it works, the both start the car. So we’re gonna do is pop the key in just test it turn the ignition on, might go solid and goes out, means it’s gonna work it’s a neutral, start the car.
So Lonsdor K518S Key Programmer takes literally less than two minutes to program the key.