How BMW ICOM do Online diagnostics for E and F series ?

To each BMW enthusiast, we offer Online diagnostics for N43/N53 engines.

What does it mean?
We will evaluate live data of INPA, sent to us by you, if necessary – will give recommendations for deeper research, if it would be required.

What do you have to do?
Prepare the screenshots of the required menus from INPA and send them to us together with a description of the problem.

List of required data for E series (E81/E82/E88/E90/E91/E92/E93/E60/E61/E63/E64).

INPA MSD80 Loader 2.023 is necessary

List of required data for F series (F10/F11).

BMW ICOM INPA for F series MSD87 Loader 3.700 is necessary

We will send the report as soon as possible with comments regarding incorrect or suspicious values, the report will be supplemented with images with marked incorrect values. We will give also suggestions and recommendations for required tests if the defect could not be recognized from the data sent.

We will help your car run smoothly again.

Following systems will be checked (initial report):
1. Basic data
Air consumption (air mass meter data)
The temperature of the engine, coolant, oil, plausibility of these data
The temperature of the exhaust system
HPFP and LPFP pressures
2. Lambda probes
Chemical activity
Heating parameters
Wide-band probes: proper Lambda readings
Control probes: the ability of voltage generation
3. NOx sensor
Proper data sending and status
Offset value
Wide-band and narrow-band Lambda data
4. NOx converter
Status: normal or damaged (from live data)
Amount of poisoning
5. Fuel mixture
Offset type adaptations: amount, the deviation between banks
Multiplicative type adaptations: amount, the deviation between banks
Additional adaptations for a cold engine
Lambda values and readings of Control probes (plausibility)
6. Injectors (data for each injector)
Actual parameters: offset and multiplicative data
Flow rate tests for low and high loads
Flow rate tests for the cold engine
Mechanical efficiency tests for Homogeneous injection (idle)
Mechanical efficiency tests for Stratified charge injection (idle)
Learnbits: status of completed/uncompleted adaptations
7. Analysis of error messages
Status (active/passive)
Importance and relationship with live data
Determination of damaged component (errors + live data)

Based on initial information, additional systems (if necessary) will be tested:
1. Check-up of fuel system: jittering of pressures, leakage, fuel distribution in the fuel tank;
2. Test of VANOS: offset adaptations, confirmed position, jittering;
3. Lambda probes: tolerance of parameters, current leakage;
4. EGR valve;
5. Crankcase valve;
6. Ignition system: misfire counters (ELM327 adapter required);
7. Generator; IBS; power management;
8. DISA valves;
9. Electric fan;
10. Engine cooling flaps;
11. Electric water pump;
12. Thermostat with electric management;
13. Oil pressure management;
14. Throttle and accelerator pedal; etc.

BMW ICOM NEXT A+B+C with 2021.01V Software Plus EVG7 4GB Diagnostic Controller Tablet PC

 

 

Be the first to comment

Leave a Reply

Your email address will not be published.


*