The instruction of DSP3+ software update

Please install ActiveSync software on your PC well before software update. Or please log in http://smelecom.com/sm/download.htm and download ActiveSync software and install it on your PC first of all.
6-1
The steps are similar among “Function Sync” and “Active Function” and “Software Update”, take “Software update” as an example:
1、Connect test connector and power supply well, shown as figure 1:

2、Click the red circle, and input the password, click button “ok”, shown as figure 2:
6-3
3、Connect USB cable to the Super DSP3+ Odometer Correction Tool, shown as figure 3:
6-4

4、If your PC is windows XP operation system, set your ActiveSync software as figure 4.1:
6-5
If your PC is windows7 operation system, set your pc as figure 4.2:
6-6

5、XP operation system set successfully, shown as figure 5.1:
6-7
Windows7 operation system set successfully, shown as figure 5.2:
6-8
6 、 Click “Update” on the screen of DSP3+, and then click “SOFTWARE UPDATE’, shown as figure 6:
6-9

Click “YES” to start software update.
Note: this process will take about 30 minutes, during this time, do not disconnect the power supply , do not disconnect USB cable, do not change any settings on PC, wait patiently please.

7、About 30 minutes later, you will see “update successfully” on the screen of DSP3+, shown as figure 7:
6-10
Software update successfully.
www.cnautotool.com

Be the first to comment

Leave a Reply

Your email address will not be published.


*