Tested: 2017 Porsche Macan add key on the bench perfectly using Yanhua Mini ACDP + Module 10
For your information, now you can obtain module 10 authorization by yourself instead of providing the dealer with the SN of Car Key Programmer ACDP to help you.
Step -by – step procedure:
Remove the BCM module from the vehicle.
All needed:
ACDP host
OBP+ICP adapter
Porsche BCM interface board
Copper pillar
20 pin cable
BAV -Key
Blank key
Next is the installation job:
Install the copper pillar, short one at below and long one on top.
D1-D4 regional figure.
Install the interface board according to D1-D4.
Confirmed D1-D4, then press download the interface board. Tighten the interface board with copper pillar.
Power the ACDP host.
Click on “Mini ACDP” APP.
Click on Porsche
Click on “New Porsche add key / all lost“.
ICP IMMO.
Main menu: MC9S12XEP100 (Mask 5M48H).
Click on “Add key (auto mode)”.
Please read the prompt carefully.
Follow the prompts to connect.
Pin detection passes.
If the detection fails, please check and clean up the test point.
It is detected that the BCM module chip has been encrypted, click on “Continue”.
Continue.
Reading Pflash data, please wait…
Please save PFLASH data file.
Reading EEPROM /DFLASH data…
Please save the original EEPROM data file.
Please save the original DFLASH data file.
Check VIN and other vehicle information.
Connect according to the prompt message.
Check the New key ID.
Choose any blank key number.
Programming key…
Please store the DFLASH data file after adding a new key.
Connect according to the prompt message.
Check pin again.
Pin detection passes, if the detection fails, please check and clean up the test point.
Check the new key ID has been added to the key list.
Writing EEPROM /DFLASH data…
Adding Porsche key completed.
Install the BCM module back to Porsche car and confirm the new key can be used normally.
Leave a Reply