XTOOL Products Record Data Guide for You

A data record guide of XTOOL for you if you meet some problem using xtool. Send the data to engineer could help them to solve your problem quickly.

Note: this guide could be used on XTOOL tablet such as XTool X100 PAD, X100 Pad2, XTOOL EZ500,XTool PS2 HD

Here is the guide:

1.Insert the key and turn on the ignition switch, connect the device to vehicles, then choose the vehicle you want to diagnose.

2.To make sure the software is the latest version, click the small pen “

“on Upper left corner to Turn on data logging, you will see the icon flashes to indicate recording, and click Manually select models to choose your car model

XTOOL - Products - Record - Data - Guide - for - You - 1

3.On the “control unit” menu, and select the part that need to be tested and enter into the diagnostic abnormal interface.

4.Once you finish all the test, click that small pen “ “ on Xtool X100 Pad2 again, Then the pop-up feedback form, and fill in the user information column of contact telephone and mailbox, point “Send” to send. The email address in this part is XTOOL tech. and your data will be sent to XTOOL engineer.

XTOOL - Products - Record - Data - Guide - for - You - 2

5. after the record data, please send the nameplate of the car model you used which will help us to match the data.

Nameplate is like this:

XTOOL - Products - Record - Data - Guide - for - You - 3

Be the first to comment

Leave a Reply

Your email address will not be published.